Fix It or Replace It
The Come-Alongs Real Range
Leo stood at the back of Uncle Magnus's truck, watching his uncle unpack his tool kit onto a dusty tarp. The mountain air was crisp and clean. They were at a forestry site high above the valley, and the big machines here were unlike anything in Leo's Fix Log.
"So," Magnus said, lifting a long, low piece of metal with a crank on the side and a cable running through it. "You know this one."
Leo nodded. "The come-along. You used it to get that broken truck down the mountain."
"Right," Magnus said. "That was its primary job that day. To pull a heavy load." He set it on the ground. "But a tool's real range isn't just what it was made for. It's what it can do when you understand it fully." He looked at Leo. "Understanding your tools fully means you have more options when the expected option isn't available."
Just then, a truck rumbled up the muddy road and sank to its axles in a deep, brown rut. The driver revved the engine. The wheels spun. The truck didn't move.
"Perfect timing," Magnus said with a smile. He walked over to the stuck truck, Leo following close behind. He crouched and looked at the mud.
"What does this job need?" Leo asked.
"Right now, it needs to be pulled backward onto solid ground," Magnus said. "But there's no tow truck up here. So, we use what we have."
Magnus carried the come-along to a huge, solid tree stump nearby. He wrapped a strap around it, then hooked the come-along's cable to the front axle of the stuck truck. He began cranking the handle slowly. The cable tightened with a sharp click-click-click. The truck groaned and then, inch by inch, slid backward out of the mud.
"Primary function," Magnus said. "Pulling a load."
Later, they were helping fix a giant log loader. The main cable that lifts the logs had to be re-spooled onto its drum. It was too loose to wind evenly.
"See this?" Magnus pointed to the drum. "The cable needs tension—it has to be pulled tight so it wraps up flat, not bunched up. The machine can't do it by itself."
He used the come-along again, hooking it between the loose cable and a nearby post. He cranked it, pulling the cable taunt. The drum wound the cable neatly into place. The loader was back in service.
"See that?" Magnus said. "Tensioning a cable. We used it just to pull something, but it did this job perfectly."
Leo recorded it in his Fix Log. The log entry read: *Log loader, loose cable, job: tension.
Leo was about to close his logbook when one of the crew members called out for help. A massive metal arm on a crane had a sheared pin in its joint. They had a new pin, but the heavy arm had sagged, and the hole for the pin was misaligned.
"Could use a couple of guys to hold it," the crew member said.
Magnus shook his head. "Guys can't hold it steady enough." He brought the come-along over again. He hooked one end to the crane's frame and the other to the sagging arm. He cranked it slowly. The giant arm lifted a fraction—just enough. The hole lined up perfectly, and the crew slid the new pin into place.
"Hold a load while a pin is replaced," Magnus said, wiping his hands. "That was a precision job for a pulling tool."
Leo was amazed. He'd seen the come-along as one thing: a winch. Now it was a puller, a tensioner, a brace.
They were about to head back to the truck when the site supervisor, Vera, came over. She looked worried. "The water pump house door is off its track again," she said. "If we can't get it closed, dust gets in and ruins the bearings."
They walked to a small metal building. The heavy sliding door was sagging off its lower track. Magnus studied it. "The door's fine, but the track is bent slightly. We could hammer it out, but that takes time." He looked at the come-along. "Or we can rig a temporary support."
He ran a chain from the top corner of the door to a hook on the wall, then hooked the come-along between the door and the chain. He cranked it until the door lifted slightly, taking the weight off the bent track. Then, he slid the door shut. It rolled perfectly.
"Temporary support," he said. "It's not the perfect fix—the track still has a bend. But the door closes, and the dust stays out. We'll weld the track true next week."
Leo wrote it down, his pencil moving fast. He looked up at his uncle. "You said the come-along is for pulling things. But today it lifted a door, held a crane arm, and tightened a cable."
Magnus nodded. "Its primary function is pulling. But when you know how it works—how the gears grip, how the cable pulls—you see it's really just a tool for applying steady, strong force in a straight line." He put a hand on Leo's shoulder. "Understanding your tools fully means you have more options when the expected option isn't available. The expected option today would have been a tow truck, a crane, and a welding crew. We didn't have those. We had one tool and a way of thinking."
Leo opened his Fix Log to the final entry for the day:
Day at forestry site.
Job: Many jobs.
Tool used: Come-along.
What it was made for: Pulling.
What it actually did: Pulled a truck, tensioned a cable, held a load, rigged a support.
Lesson: A tool is more than its name. It's what you can make it do safely.
He closed the logbook and smiled. The come-along was small, but its range was as big as the whole mountain.